Maintained by: NLnet Labs

[Unbound-users] Unbound stop working without error-log

lst_hoe02 at kwsoft.de
Tue Nov 2 11:53:38 CET 2010


Zitat von "W.C.A. Wijngaards" <wouter at NLnetLabs.nl>:

> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Hi Andreas,
>
> On 11/02/2010 11:38 AM, lst_hoe02 at kwsoft.de wrote:
>> The request is orginating at localhost with "nameserver 127.0.0.1" as
>> the only content in resolv.conf so routing should not be the problem. If
>> have disabled "interface-automatic: yes" because the machine is
>> multihomed and have bound unbound to the needed interfaces "by hand"
>> with the "interface:" statement. I have also set "do-ip6: no" because
>> the machine has ipv6 capabilities but no ipv6 connectivity until yet.
>
> Looks like this is reasonable config to me.
>
> So the packetdump was from the eth interface, and did not include lo0
> traffic, that is why the reply is not in the packet capture?
>
> Best regards,
>    Wouter

The packet capture is from the connection unbound (10.5.0.1) ->  
upstream bind (10.5.0.3) to see if bind deliver results or not. If  
have done no localhost capture but i can try later. It is a bit  
difficult because it's the main resolver for the internal net and  
people don't like to be without internet access today ;-)

Regards

Andreas